Dongguan Guorong Polishing Wax Factory

The role and use of abrasives on polishing wax require the selection of abrasives, which must be granular materials with high hardness and certain mechanical strength, which are the main components of polishing wax. The abrasive should have the following requirements: the hardness is higher than the hardness of the metal on the surface to be polished and good toughness, otherwise grinding cannot be achieved. It has good heat resistance and thermal stability, because during the polishing process, the temperature of the polished surface increases sharply with the high-speed rotation of the polishing wheel. (The temperature can reach above degrees) If the abrasive is prone to thermal decomposition, its hardness and toughness will decrease, affecting the polishing effect. It has good stability. At the working temperature, the abrasive does not have any chemical reaction with the surface to be polished. Otherwise, the inherent mechanical properties of the abrasive will change, affecting the smoothness of the surface to be polished.
Selection of additives: Add a small amount of additives to the polishing wax. After polishing, a protective film can be formed on the metal surface to prevent the metal surface from being contaminated by hand sweat and oxidized by moisture. During the polishing process, the metal surface undergoes subtle reactions. It can make metal surfaces emit blue light. Adding an appropriate amount of amine alcohol substances to the polishing wax can enhance the miscibility of the material, reduce the stickiness of the wax, improve the toughness and plasticity, and ensure the uniformity of the entire wax body. At the same time, the finish of the metal surface can be improved.
Add a small amount of spices to the polishing wax to give the polishing wax a fragrant smell, which can relieve fatigue at work. The developed polishing wax is a solid mixture of polishing materials, mainly composed of grease, abrasives and additives. Among them, the type of abrasive, the size of the particle size and the type and ratio of grease materials are all important factors for the quality of polishing. At present, the quality of domestically produced polishing waxes is mostly at the mid- to low-end level. Most domestic stainless steel products companies (watch straps, watch cases, high-end tableware, high-end stainless steel utensils, etc.) still use imported polishing wax. Based on this situation, high-grade polishing wax (purple wax) (green green wax) for stainless steel was scientifically developed. And visit relevant experts and professors from universities and research institutes. Consult a large number of domestic and foreign references. Scientific analysis and careful scientific research are carried out from the selection of material proportions and processes, breaking the convention and adopting advanced, scientific and effective self-treatment to break the limitations of the use of raw materials, and boldly and scientifically select the use of raw materials. and the adoption of advanced technology. Unnecessary processing of raw materials before use (for example, the requirements for feeding temperature are closely related to the temperature control during discharging) can achieve good and high-quality results. After trial and use by more than ten stainless steel product companies, it has received unanimous praise and recognition.